Assembly Instruction

Made in Vietnam - r05 Page 2 of 4
1 A) Fit dowels of bottom panel into corresponding
holes of left/right side panels, and fasten with 2 bolts, 2
spring washers and 2 flat washers per panel as shown.
Secure, but do not over tighten, bolts with a phillips
head screwdriver.
B) Fit dowels of center panel into corresponding holes in
the bottom panel as shown.
KENDEL 44” SLIDING DOOR BOOKCASE
2 With the assistance of another adult, position unit upright.
Fit dowels of assembled unit into corresponding holes of top
panel, and fasten with 4 bolts, 4 spring washers and 4 flat
washers as shown.
3 A) Insert wire managment cover into
corresponding window of back panel as shown.
B) Attach back panel with 14 small screws using a
screwdriver as shown. Do not over tighten screws.
4 A) Insert 8 shelf pins into holes at the desired shelf
height.
B) Tilt adjustable shelves and place into assembled unit
as shown. Make sure shelves are securely supported by
shelf pins.
left side
panel
right side
panel
center
panel
bottom
panel
top
panel
back
panel
adjustable
shelves
NOTE: Do not over
tighten the bolts
NOTE: Do not over
tighten the screws
wire managment
cover
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
A
B
A
B
A
A
NOTE: Make sure apron of
bottom panel is facing the
front as shown
B
A