Assembly Instruction

Made in Vietnam - r06 Page 4 of 4

KENDEL

22” OPEN BOOKCASE

6 Safety Mounting Instructions

For added safety and stability, it is recommended that the

wall mounting hardware be installed. For safe mounting, it is

essential to use wall anchors appropriate to your wall type

(i.e. plaster, drywall, concrete, etc.). Mount to wood studs

whenever possible.

A) Locate pilot holes on back of unit, and attach 1 bracket

using 2 medium screws as shown.

B) Determine the final location of unit. Mark position on the

wall, approximately 2" below the wall bracket mounted to the

back of the unit.

C) Drill a hole in the wall stud. If the wall stud is not

available, drill a hole in the wall that is slightly smaller in

diameter than the plastic anchor. Gently tap the plastic

anchor until the flange of the anchor is flush with the wall.

D) Attach 1 bracket to the wall by inserting 2 large screws

trough the bracket and into the plastic anchors in the wall.

E) Place the unit so the wall brackets on the back edge are

aligned with the wall brackets on the wall.

F) Lace one end of the wall strap through both brackets,

and into the other end of the strap.

G) Pull the strap tightly until secure.

H) Repeat steps A-G for remaining wall brackets and wall

straps.

NOTE:

If you are unsure about your wall type or what

mounting method you should use, consult a

qualified professional or your local hardware store.

medium

screw

bracket

plastic

anchor

large

screw

wall

strap

Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com

WALL MOUNTING ASSEMBLY FOR MULTIPLE UNITS

CLEANING & CARE

Clean surfaces with a dry or damp soft cloth. Do not use abrasive cleaners. Do not use furniture wax or polish as

the unit is finished with a protective clear lacquer. It is recommended to use coasters to protect surface from heat

and water.

bracket