Assembly Instruction

Page 5 of 5
2) Depth adjustment:
Loosen screw A, push hinge arm
forwards or backwards, re-tighten
screw
HINGE ADJUSTMENT
If the doors do not appear square or aligned,
loosen or tighten the appropriate screws on
each case hinge as illustrated.
1)
Side to side adjustment:
Loosen screw A, adjust gap
with screw B and re-tighten
screw A. A.
HUXLEY
LARGE SIDEBOARD
Made in China - r10 Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
OPTIONAL SAFETY MOUNTING INSTRUCTIONS
For added safety and stability, it is recommended that the wall
mounting hardware be installed. For safe mounting, it is
essential to use wall anchors appropriate to your wall type (i.e.
plaster, drywall, concrete, etc.). Mount to wood studs
whenever possible.
A) Determine the final location of unit. Mark position on the wall,
approximately 2” below the top of the unit as shown.
B) Drill a pilot hole in the wall stud. If a wall stud is not available,
drill a hole in the wall that is slightly smaller in diameter than the
plastic anchor. Gently tap the plastic anchor until the flange of
the plastic anchor is flush with the wall.
C) Insert 1 large screw through end of wall strap and through
plastic anchor in the wall as shown.
D) Insert small screw through end of wall strap and into back of
unit as shown.
Mounting assembly is now complete.
NOTE: If you are unsure about your wall
type or what mounting method you should
use, consult a qualified professional or your
local hardware store.
large
screw
wall
strap
small
screw
WALL
NOTE: Insert screws 3/4"-1"
from the edge of the strap
plastic
anchor
A
1
2
A
B