Assembly Instruction

Customer Service 800-967-6696 | http://www.crateandbarrel.com

HARDWARE

1 Place table top assembly upside down on a padded

surface. Remove drawer by pivoting 2 drawer stops into an

upright position as illustrated. Slide drawer out and set

aside.

Thank you for purchasing the Havana Console. This

page lists all the contents included in the box. Please

take time to identify the hardware as well as the individual

components of this product. As you unpack and prepare

for assembly, place the contents on a carpeted or padded

area to protect them from damage.

Note: 2 people are required to safely assemble this

product.

COMPONENTS

2 - leg frames

(1 left, 1 right)

1 - table top

assembly

TOOLS REQUIRED

Phillips head screwdriver (included)

x 2

HAVANA CONSOLE

Page 1 of 3

Made in Indonesia - r02

Missing hardware? Please call 800.606.6387 for

replacements.

8 - flat head

screws

4 - round head

screws

2 - wood dowels

1 - shelf

PAGE 1
HAVANA CONSOLE HARDWARE 4 - round head screws 8 - flat head screws 2 - wood dowels Missing hardware? Please call 800.606.6387 for replacements. Thank you for purchasing the Havana Console. This page lists all the contents included in the box. Please take time to identify the hardware as well as the individual components of this product. As you unpack and prepare for assembly, place the contents on a carpeted or padded area to protect them from damage.
PAGE 2
HAVANA CONSOLE 2 Insert 1 wood dowel in the right and left leg frames as shown. 4 Fit right leg frame into position and loosely attach with 2 round head screws. Do not fully tighten the screws. 3 Place shelf into position, aligning holes in metal corner brackets with holes in left leg frame. Loosely attach 2 round head screws through brackets and into the legs. Do not fully tighten screws. 5 Align wood dowels of leg frames with corresponding holes in the table top and fit into position.
PAGE 3
HAVANA CONSOLE B A 6 A. Secure leg frames with 4 flat head screws per leg frame. Fully tighten each bolt with a phillips head screwdriver. B. At this point fully tighten all 4 round head screws that attach the shelf with a phillips head screwdriver. 7 Slide drawer back into table top assembly, fitting slots on drawer sides onto rails. x2 CLEANING AND CARE Clean surfaces with a dry or damp soft cloth. Do not use abrasive cleaners.