Assembly Instruction

Customer Service 800-967-6696 | http://www.crateandbarrel.com
5 A. Place frame in desired location
against the wall and mark the
location of the holes in each bracket.
B. Wrap 2 wall straps around the
rear verticals of the main frame as
shown.
C. Pre-drill 1/4"diameter pilot holes
in the wall corresponding to the
holes in the straps.
D. Insert 2 drywall anchors into the
holes until the head is flush with the
surface of the wall. Gently tap into
position with a hammer if necessary.
E. Insert 1 screw through each wall
strap and into the drywall anchor.
Secure each screw with a phillips
head screwdriver.
x 24
FLEX BOOKCASE
Page 2 of 2
Made in Taiwan - r02
2 Fit brackets of remaining main frame into ends of
crossbars. Secure each crossbar with 1 bolt, fully
tightening with the allen wrench. At this point, fully
tighten 12 bolts installed in Step 1 with the allen wrench.
4 With the assistance of another adult, turn assembly
upright. Carefully place 5 glass shelves into position,
making sure each is firmly supported by the rubber
bumpers. Assembly is now complete.
3 A. Insert 4 levelers into the bottom of the legs as
shown. Turn each leveler clockwise to secure.
B. Adhere 2 rubber bumpers to each crossbar as shown.
A
B
OPTIONAL WALL ATTACHMENT
These instructions are for drywall mounting only. For safe
installation it is essential to use hardware appropriate for your
wall type. Mount to wood wall studs whenever possible. If
you are unsure of what type of fasteners to use, consult your
local hardware store or a qualified professional. This product
is only deterrent, it is not a substitute for proper adult
supervision.