Assembly Instruction

Made in Taiwan - r04 Page 2 of 2
2 A) Attach seat adjuster to seat as shown. Make
sure arrow on adjuster points toward the front edge of
the seat. Secure seat adjuster with 2 small bolts as
shown, using an allen wrench.
B) Secure seat adjuster to seat with 2 large bolts as
shown.
FELIX OFFICE CHAIR
NOTE: Make
sure arrow on
adjuster points
towards front
edge of seat
FRONT
3 A) Firmly press fit the stems of 5 casters into holes on
the underside of the base.
B) Fit bottom of gas lift into hole of base as shown.
gas
lift
base
caster
A
B
4 Fit top of gas lift into corresponding hole
on the bottom of the seat assembly as
shown.
NOTE: Finalize assembly by sitting heavily
on the chair a few times. This will secure
all the component connections.
VIEW FROM
BELOW
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
OPERATING
INSTRUCTIONS
1 HEIGHT ADJUSTMENT:
While sitting in the chair, pull the lever
up to lower the seat. To raise the seat,
take your weight off the chair and pull the lever up.
2 LOCKING THE SEAT:
While sitting in the chair, lean your weight forward
and push the lever in.
3 UNLOCKING THE SEAT:
While sitting in the chair, lean you weight forward and
pull the lever out.
4 ADJUSTING THE TENSION:
Tighten the knob to increase the back tension (less
rocking). Loosen the knob to decrease the back
tensions (more rocking).
1
2
3
4
A
B
B
A
small bolt
large bolt