Assembly Instruction

FARROW ENTRYWAY CABINET

Made in Vietnam - r03 Page 2 of 4

Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com

1 Place bottom panel onto a clean, padded surface.

Attach 4 legs to bottom panel with 2 large bolts, 2

spring washers and 2 large flat washers per leg as

shown. Secure, but do not over tighten, bolts using an

allen wrench.

2 A) With assistance of another adult, position bottom

panel as shown. Attach left and right side panels to

bottom panel with 2 large screws per side as shown.

Secure, but do not over tighten, screws using a phillips

head screwdriver.

B) Attach partition to bottom panel with 2 large screws

as shown.

3 Fit pre-assembled dowels of left/right side panels

and partition into corresponding holes of top panel.

Attach top panel to left/right side panels and partition

with 6 small bolts, 6 spring washers and 6 small flat

washers as shown, using a screwdriver.

4 With the assistance of another adult, position

assembled unit upright. Attach front frame to assembled

unit with 8 small bolts, 8 spring washers and 8 small

flat washers as shown, using a screwdriver.

NOTE: Do not over

tighten the bolts

bottom

panel

leg

left side

panel

partition

right side

panel

top

panel

NOTE: Make sure

brackets of side panels

are positioned towards

each other as shown

NOTE: Make sure brackets

of top panel are positioned

towards the front of assembly

as shown.

front frame