Assembly Instruction

FARROW MEDIA GAMING TOWER
Made in Vietnam - r02 Page 2 of 5
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
3 A) Fit pre-assembled dowels of top and bottom fixed
panels into corresponding holes of left and right side
panels.
B) Secure bottom fixed panel to left and right side
panels with 4 small bolts, 4 spring washers and 4 small
flat washers, using a phillips head screwdriver. Do not
over tighten the bolts.
4 Place bottom panel onto a clean, padded surface.
Attach 4 legs to bottom panel with 2 large bolts, 2
spring washers and 2 large flat washers per leg as
shown. Secure, but do not over tighten, bolts using an
allen wrench.
top panel
A
top fixed
panel
left and right
side panels
right side
panel
bottom fixed
panel
left side
panel
NOTE: Do not over
tighten the bolts
leg
bottom
panel
NOTE: Make sure arrows
on each cam point toward
nearest edge with holes
1 A) Insert 2 cams into top panel as shown. Make sure
arrows on each cam point toward nearest edge with holes.
B) Insert 3 cams into left and right side panels as shown.
2 Insert 8 cam screws into front frame as shown.
Secure, but do not over tighten, cam screws using a
phillips head screwdriver.
front frame
NOTE: Do not over
tighten cam screws
B
A
B
NOTE: Make sure pilot holes
of left and right side panels
are positioned towards the
front during assembly as shown