Assembly Instruction

FARROW 44” CORNER MEDIA CONSOLE
Made in Vietnam - r03 Page 2 of 4
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
1 A) Place bottom panel onto a clean, padded surface.
Attach 4 legs to bottom panel with 2 large bolts, 2
spring washers and 2 large flat washers per leg as
shown. Secure, but do not over tighten, bolts using an
allen wrench.
B) Attach 1 bottom crossbar to bottom panel with 2
small bolts, 2 spring washers and 2 small flat washers
as shown, using a phillips head screwdriver.
C) Secure bottom crossbar to bottom panel with 1 large
screw, using a screwdriver.
2 With the assistance of another adult, fit pre-assembled
dowels of left/right side panels, left/right back panels
and partition into corresponding holes of bottom panel.
Secure bottom panel with 11 large screws, using a
screwdriver.
3 Fit pre-assembled dowels of left/right side panels,
left/right back panels and partition into corresponding
holes of top panel. Attach top panel with 8 small bolts,
8 spring washers and 8 small flat washers as shown,
using a screwdriver.
4 With the assistance of another adult, position
assembled unit upright. Attach front frame to assembled
unit with 12 small bolts, 12 spring washers and 12
small flat washers as shown, using a screwdriver.
partition
right panel
left panel
bottom
panel
left back
panel
right back
panel
NOTE: Do not over
tighten the bolts
bottom
panel
leg
top
panel
NOTE: Make sure crossbar
of top panel is positioned
towards the front of assembly
as shown.
front frame
A
B
A
bottom
crossbar
C
B