Assembly Instruction

ELLIS 6 DRAWER DRESSER
Made in Vietnam R05 Page 3 of 4
8 Insert 6 drawer assemblies into the case, fitting
wheels of drawer glide into rail of case glides.
Assembly is now complete.
VIEW FROM
BELOW
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth. Do not use
abrasive cleaners. Do not use furniture wax or polish as the
wood is finished with a protective clear lacquer.
Customer Service 800.967.6696 | www.crateandbarrel.com
7 Slide drawer bottom panel into the groove at the
base of drawer assembly.
8 Attach the drawer right side panel to the
assembly with 4 screws. Secure with a Phillips
head screwdriver. Repeat steps 5-7 for each
drawer assembly.
6 Attach the drawer left side panel to the drawer
front panel and drawer back panel with 4 screws.
Secure with a Phillips head screwdriver. Do not
over tighten the screws.
Make sure the wheels of the
drawer slides face out and
towards the back
5 Carefully place assembled unit upright. Fit top panel
onto assembled unit by aligning dowels with
corresponding holes. Secure top panel with 12 bolts,
12 spring washers, and 12 flat washers using a
Phillips head screwdriver.
NOTE: Do not over
tighten the screws.