Assembly Instruction

ELLIS 6 DRAWER DRESSER
Made in Vietnam R05 Page 2 of 4
1 With the assistance of another adult, carefully lay
back panel on padded surface. Fit left side panel,
right side panel and middle panel onto back panel
by aligning pre-assembled dowels with corresponding
holes. Secure with 8 bolts, 8 spring washers, and 8
flat washers using a Phillips head screwdriver.
4 A) Carefully fit front frame onto assembled unit by
aligning dowels with corresponding holes. As shown,
secure front frame with 6 bolts, 6 spring washers, and
6 flat washers using a Phillips head screwdriver.
B) Secure connecting plates onto front frame with
removed screws using a Phillips head screwdriver.
2 A) Attach support leg onto assembled unit as
shown. Turn clockwise to secure.
B) Turn 2 pre-installed connecting plates 90º
clockwise on middle panel as shown with a Phillips
head screwdriver.
3 Remove pre-installed screws located in front frame
as shown with a Phillips head screwdriver. Set aside
screws.
Customer Service 800.967.6696 | www.crateandbarrel.com
Make sure the wheels
face towards
the front.
A
A
B
B
A
A
B
B
90º
NOTE: To remove
screws, turn Phillips
head screwdriver
counterclockwise.