Assembly Instruction

ELLIS FOUR DRAWER CHEST
Made in Vietnam r04 Page 3 of 3
5 Insert bottom drawer panel into grooves on
assembled drawer unit.
6 Attach back drawer panel onto assembled
drawer unit by aligning pre-assembled dowels with
corresponding holes. Secure back drawer panel with
4 screws with a Phillips head screwdriver.
7 Attach handle to front drawer panel with 3
handle screws. Secure with Phillips head
screwdriver, but do not over tighten. Repeat steps
4-7 for each drawer assembly.
8 Insert 4 drawer assemblies into the case, fitting
wheels of drawer glide into rail of case glides.
Assembly is now complete.
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth. Do not use
abrasive cleaners. Do not use furniture wax or polish as the
wood is finished with a protective clear lacquer.
Customer Service 800.967.6696 | www.crateandbarrel.com
5 Slide drawer bottom panel into the groove at
the base of the assembly.
6 Attach the drawer right side panel to the assembly
with 4 screws. Secure with a Philllps head screwdriver.
Repeat steps 4-6 for each drawer assembly.