Assembly Instruction

Customer Service 800-967-6696 | http://www.crateandbarrel.com
ELLIS BUFFET
Made in China - r05
Page 2 of 4
1 With the assistance of another adult, position 2 side
panels and 1 divider panel as shown. Attach 2 lower
shelves to the panels with 8 bolts, 8 split washers and 8
washers. Fully tighten each bolt with a phillips head
screwdriver.
3 A. Position back panel as shown. With the assistance of
another adult, open doors and place case assembly on back
panel, aligning corresponding holes. Attach side panels with
6 bolts, 6 split washers and 6 washers.
B. Attach 2 door pulls with 3 short wood screws per pull
and secure with phillips head screwdriver.
4 A. Place the top panel upside down. With the assistance
of another adult, align holes in the case assembly with
corresponding holes in the top panel as shown. Secure with
8 bolts, 8 split washers and 8 washers.
B. Attach divider to case assembly with 1 long wood screw.
Secure with a phillips head screwdriver.
2 A. Position front panel on floor face down as shown.
Align corresponding holes in side panels and divider panel
with front panel. Fasten side panels with 3 bolts, 3 split
washers and 3 washers per panel with a screwdriver.
B. Fasten 1 long wood screw into divider panel from below
with a phillips head screwdriver.
x 8
A
B
B
x 6
x 2
x 6
A
B
x 8
A
B
B
NOTE:
Do not overtighten
the bolts.