Assembly Instruction

ELEMENTS MEDIA CART
Page 3 of 4
Made in China - r08
7 A. Insert 12 cam screws into the top and bottom of the
center panel as indicated.
B. Insert 2 wire supports at desired location on top and
bottom of center panel. Make sure wire supports are
aligned with one another.
8 Fit 2 wide uprights and 4 narrow uprights into position.
Secure cams on each wide upright above and below the
center panel with a screwdriver.
Center panel
(upside down)
A
B
6 Secure both wide uprights to top panel by locking all 6
lower cams with a phillips head screwdriver. Turn all
cams clockwise as illustrated until cam firmly engages
the cam screw.
Cam in
unlocked
position
Cam in
locked
position
9 A. Attach 6 cam screws and 1 wire support to top
side of bottom panel.
B. Align cam screws with corresponding holes and dowels
in the assembly and fit bottom panel into position. Fully
tighten 6 cams with a screwdriver to secure the assembly.
A
B
Customer Service 800.967.6696 | www.crateandbarrel.com