Assembly Instruction

ELEMENTS MEDIA CART
Page 2 of 4
Made in China - r08
2 Insert 6 cams into each wide upright as shown. Make
sure that the arrow on each cam points towards the closest
edge.
3 Attach 6 cam screws to the underside of the top panel
with a phillips head screwdriver. Do not over tighten
screws.
4 A. Fit 2 wide uprights and into position, aligning
dowels and cam screws with corresponding holes in top
panel. Make sure the cams on the wide uprights face
inward.
B. At this point decide the location of the center support.
Center support can be installed centered or left or right of
center. Insert 1 wire support into holes corresponding
with the desired location of the center support.
5 Fit 4 narrow uprights into position, aligning dowels with
corresponding holes in top panel.
Top panel
(upside down)
A
Wide Upright
B
Customer Service 800.967.6696 | www.crateandbarrel.com