Assembly Instruction

DRAKE OFFICE CHAIR
Made in China - r06 Page 2 of 2
3 Attach back to adjustment mechanism as shown
with 4 large bolts. Secure bolts with an small allen
wrench.
4 A) Position assembly
upright. Attach 2 arms to
assembly with 2 arm bolts
per arm as shown, using an
large allen wrench.
B) Fit hole of seat assembly
into correpsonding hole of
leg assembly as shown.
Press firmly to secure.
Assembly is now complete.
2 Attach adjustment mechanism to bottom of seat
as shown with 4 small bolts. Secure, but do not over
tighten, bolts with an small allen wrench.
A
B
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth.
Do not use abrasive cleaners.
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
small
bolt
HEIGHT ADJUSTMENT
While sitting in the chair, pull the level up to
lower the seat. To raise the seat, take your
weight off the chair and pull the lever up.
NOTE: Finalize assembly by
sitting heavily on the chair a few
times. This will secure all the
component connections.
large
bolt
front
back
NOTE: Do not over
tighten the bolts
SIDE VIEW
TOP VIEW
Install bolts in
each corner
as shown
FRONT
BACK
SIDE VIEW
TOP VIEW
Install bolts in
middle holes
as shown
FRONT
BACK