Assembly Instruction

Made in China - r06 Page 3 of 3

DRAKE MEDIA STAND

WALL

CLEANING AND CARE

Clean surfaces with a dry or damp soft cloth.

Do not use abrasive cleaners. Do not use

furniture wax or polish as the wood is finished

with a protective clear lacquer.

OPTIONAL WALL MOUNTING INSTRUCTIONS

For added safety and stability, it is recommended that the

wall mounting hardware be installed. For safe mounting, it

is essential to use wall anchors appropriate to your wall type

(i.e. plaster, drywall, concrete, etc.). Mount to wood studs

whenever possible.

A) Attach 1 wall bracket to assembled unit as shown,

using 1 small screw.

B) Determine the final location of dresser unit. Mark

position on the wall, approximately 2" below the bracket

mounted to the back of the unit.

C) Drill a pilot hole in the wall stud. If the wall stud is not

available, drill a hole in the wall that is slightly smaller in

diameter than the anchor. Insert plastic anchor into hole

and secure using a phillips screwdriver.

D) Attach the wall bracket to the wall by inserting 1 large

screw through the wall bracket and into the plastic anchor

in the wall.

E) Place the unit so the wall bracket on the back edge is

aligned with the wall bracket on wall.

F) Lace one end of the wall strap through both brackets,

and into the other end of the strap.

G) Pull the strap tightly until secure.

Wall mounting assembly is now complete.

NOTE: If you are unsure about your

wall type or what mounting method

you should use, consult a qualified

professional or your local hardware

store.

Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com