Assembly Instruction

Page 4 of 4
DELAVAN
MEDIA GAMING TOWER
Made in Vietnam - r05 Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
For added safety and stability, it is recommended
that the wall mounting hardware be installed. For
safe mounting, it is essential to use wall anchors
appropriate to your wall type (i.e. plaster, drywall,
concrete, etc.). Mount to wood studs whenever
possible.
A) Attach wall bracket to top of unit using 2 small
screws as shown.
B) Determine the final location of unit. Mark
position on the wall, approximately 2" below the wall
bracket mounted to the back of the unit.
C) Drill a hole in the wall stud. If the wall stud is not
available, drill a hole in the wall that is slightly smaller
in diameter than the anchor. Gently tap the plastic
anchor until the flange of the anchor is flush with the
wall.
D) Attach wall bracket to the wall by inserting 2
large screws, and into the plastic anchor in the wall.
E) Place the unit so the wall brackets on the back
edge are aligned with the wall brackets on the wall.
F) Lace one end of the wall strap through both
brackets, and into the other end of the strap.
G) Pull the strap tightly until secure.
Repeat steps A-G for remaining wall brackets and
wall straps.
Wall mounting assembly is now complete.
NOTE:
If you are unsure about your
wall type or what mounting
method you should use, consult
a qualified professional or your
local hardware store.
A
C
small
screw
wall
bracket
plastic
anchor
large
screw
wall
strap
D
F
wall
bracket
WALL
2) Depth adjustment:
Loosen screw A, push hinge arm
forwards or backwards, re-tighten
screw A and secure screw B with
a 1/4 turn clockwise.
3) Height adjustment:
Loosen screw C, adjust
door height and re-
tighten screw C.
C
C
3
HINGE ADJUSTMENT
If the doors do not appear square or aligned,
loosen or tighten the appropriate screws on
each case hinge as illustrated.
A
B
1
1) Side to side adjustment:
Loosen screw A, adjust gap
with screw B and re-tighten
screw A.
A
B
2
SAFETY MOUNTING INSTRUCTIONS: