Assembly Instruction

Page 4 of 4

DELAVAN

62” MEDIA CONSOLE

Made in Vietnam - r08 Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com

For added safety and stability, it is recommended

that the wall mounting hardware be installed. For

safe mounting, it is essential to use wall anchors

appropriate to your wall type (i.e. plaster, drywall,

concrete, etc.). Mount to wood studs whenever

possible.

A) Attach wall bracket to back of unit using 2 small

screws as shown.

B) Determine the final location of unit. Mark

position on the wall, approximately 2" below the wall

bracket mounted to the back of the unit.

C) Drill a hole in the wall stud. If the wall stud is not

available, drill a hole in the wall that is slightly smaller

in diameter than the anchor. Gently tap the plastic

anchor until the flange of the anchor is flush with the

wall.

D) Attach wall bracket to the wall by inserting 2

large screws, and into the plastic anchor in the wall.

E) Place the unit so the wall brackets on the back

edge are aligned with the wall brackets on the wall.

F) Lace one end of the wall strap through both

brackets, and into the other end of the strap.

G) Pull the strap tightly until secure.

Repeat steps A-G for remaining wall brackets and

wall straps.

Wall mounting assembly is now complete.

NOTE:

If you are unsure about your

wall type or what mounting

method you should use, consult

a qualified professional or your

local hardware store.

OPTIONAL WALL MOUNTING ASSEMBLY

WALL