Assembly Instruction
ASSEMBLY
1) Shut off the main electrical supply from the main fuse
box/circuit breaker.
2) Carefully unpack all fixture parts and hardware. Lay items
out on a clear workspace.
3) Insert cord through the metal ring as shown.
4) Attach socket assembly and diffuser to metal ring. At
this point, secure lamp shade by threading nut onto socket
assembly.
5) Gently pull wiring down from ceiling junction box and allow
it to hang.
6) Remove the mounting plate from the canopy by turning
collar counter-clockwise.
7) Carefully inspect the pendant’s fixture wires:
• Neutral fixture wire = white
• Hot fixture wire = black
•Ground wire = green
8) Attach the ground wire from the fixture to the ground
junction box wire from the outlet (usually green or bare wire).
Fasten each together with a wire nut and wrap the
connection with electrical tape. Be sure no strands are
exposed.
9) Connect the neutral fixture wire to the neutral junction box
wire (usually white). Fasten each together with a wire nut
and wrap the connection with electrical tape.
10) Connect the hot fixture wire to the hot junction box wire
(usually black). Fasten each together with a wire nut and
wrap the connection with electrical tape.
DO NOT REVERSE THE HOT AND NEUTRAL
CONNECTIONS OR SAFETY WILL BE COMPROMISED.
11) Gently tuck the wire connections neatly into the ceiling
junction box.
12) Attach the mounting plate to the ceiling outlet box using
the enclosed mounting screws and tighten screws with a
phillips head screwdriver.
13) Push canopy up over the mounting plate until it is flush
with the ceiling.
14) Push collar through the hole in the canopy and thread
onto mounting plate. Turn collar clockwise until the canopy
is flush with the ceiling.
15) Insert 1 - type A 60W bulb (not included) into the socket.
DO NOT EXCEED SPECIFIED WATTAGE.
16) Restore power to junction box and test fixture.
Assembly installation is now complete.
canopy
mounting
plate
ground
screw
nut
wire
nuts
metal
ring
diffuser
socket
assembly
60W light bulb
(not included)
lamp shade
collar
Made in China - r02 Page 2 of 2
DANE PENDANT
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com