Assembly Instruction

CONTOUR MEDIA STAND

Made in China - r03 Page 4 of 4

bracket

anchor

long

screw

wall

strap

short

screw

Customer Service 800.967.6696 | www.crateandbarrel.com

8 Safety Mounting Instructions

For added safety and stability, it is recommended that the

wall mounting hardware be installed. For safe mounting, it

is essential to use wall anchors appropriate to your wall type

(i.e. plaster, drywall, concrete, etc.). Mount to wood studs

whenever possible.

A) Attach 1 bracket to top of media stand as shown, using

1 small screw.

B) Determine the final location of media stand. Mark

position on the wall, approximately 2" below the bracket

mounted to the back of the cabinet.

C) Drill a hole in the wall stud. If the wall stud is not

available, drill a hole in the wall that is slightly smaller in

diameter than the anchor. Squeeze 2 flanges of plastic

anchor and fit into pre-drilled hole. Gently tap the plastic

anchor until the flange of the anchor is flush with the wall.

D) Attach the remaining bracket to the wall by inserting 1

large screw through the wall bracket and into the wall

anchor in the wall.

E) Place the unit so the bracket on the back edge is allowed

with the bracket on the wall.

F) Lace one end of the wall strap through both brackets,

and into the other end of the strap.

G) Pull the strap tightly until secure.

Assembly is now complete.

NOTE:

If you are unsure about your wall type or what

mounting method you should use, consult a

qualified professional or your local hardware

store.

This unit can safely hold up to a 24" traditional

(CRT) TV without tipping. This unit can support

up to a 300 lb. TV. Please refer to TV

manufacturer’s recommendations for support

of a flat screen TV.