Assembly Instruction

CONTOUR MEDIA STAND
Made in China - r03 Page 2 of 4
1 A) Insert 2 barrel nuts and 2 cams into left and
right side panels as shown. Make sure threaded hole
of each barrel nut is vertically aligned with holes of
side panel. Make sure arrows on each cam points
towards the nearest edge with holes.
B) Insert 4 wood dowels and 2 cams into left and
right front panels.
C) Insert 2 cam screws and 4 wood dowels into
bottom panel as shown. Secure cam screws, but do
not over tighten with a phillips head screwdriver.
D) Insert 6 cam screws and 4 wood dowels into top
panel as shown.
side
panels
2 Fit dowels of bottom panel into holes of side
panels. Secure bottom panel with 4 short bolts, 4
spring washers, and 4 flat washers as shown, using
an allen wrench.
A
B
C
D
3 A) Insert 4 wood dowels into bottom panel as
shown.
B) Attach 4 legs onto assembled unit as shown.
Secure each leg with 1 long bolt, 1 spring washer,
and 1 flat washer, using an allen wrench.
C) Insert 1 adjustable foot into each leg as shown.
A
B
C
front panels
bottom
panel
top
panel
Make arrow on
each cam points
towards nearest
edge with holes
Make sure hole
of each barrel
nut is vertical
Customer Service 800.967.6696 | www.crateandbarrel.com