Assembly Instruction

CONTOUR AUDIO TOWER
Made in China - r06 Page 2 of 8
1 A) Insert 2 barrel nuts, 2 cams, and 4 wood
dowels into left and right side panels as shown.
Make sure threaded hole of each barrel nut is vertically
aligned with holes of side panel. Make sure arrows on
each cam points towards the nearest edge with holes.
B) Insert 4 cam screws into top panel as shown.
Secure cam screws, but do not over tighten with a
phillips head screwdriver.
side
panels
2 Fit dowels of side panels into holes of bottom
panel. Secure bottom panel with 4 short bolts, 4
spring washers, and 4 flat washers as shown.
Secure bolts with an allen wrench.
A B
3 A) Insert 4 wood dowels into bottom panel as
shown.
B) Attach 4 legs onto assembled unit as shown.
Secure each leg with 1 long bolt, 1 spring washer,
and 1 flat washer, using an allen wrench.
C) Insert 1 adjustable foot into each leg as shown.
A
B
C
top
panel
Make sure arrow on
each cam points
towards nearest
edge with holes
Make sure hole
of each barrel
nut is vertical
Customer Service 800.967.6696 | www.crateandbarrel.com