Assembly Instruction

Made in Indonesia - r06 Page 3 of 3
CABRIA BUFFET AND HUTCH
Customer Service 800.967.6696 | Latest instructions avaliable at www.crateandbarrel.com
WALL MOUNTING ASSEMBLY WITH HUTCH
For added safety and stability, it is recommended that the
wall mounting hardware be installed. For safe mounting, it
is essential to use wall anchors appropriate to your wall
type (i.e. plaster, drywall, concrete, etc.). Mount to wood
studs whenever possible.
A) Attach 1 wall fitting to assembled unit as shown, using
1 small screw.
B) Determine the final location of unit. Mark position on
the wall, approximately 2" below the bracket mounted to
the back of the unit.
C) Drill a pilot hole in the wall stud. If the wall stud is not
available, drill a hole in the wall that is slightly smaller in
diameter than the anchor. Gently tap the plastic anchor
until the flange of the anchor is flush with the wall.
D) Attach the wall fitting to the wall by inserting 1 large
screw through the wall fitting and into the plastic anchor
in the wall.
E) Place the unit so the wall fitting on the back edge is
aligned with the wall fitting on wall.
F) Lace one end of the wall strap through both fittings,
and into the other end of the strap.
G) Pull the strap tightly until secure.
H) Repeat steps A-G for remaining wall fitting and wall
strap.
Wall mounting assembly is now complete.
NOTE:
If you are unsure about your wall type or what
mounting method you should use, consult a
qualified professional or your local hardware
store.
A
wall fitting &
small screw
C
F
wall strap
plastic
anchor
D
large screw
CLEANING & CARE
Clean surfaces with a dry or damp soft cloth. Do not use
abrasive cleaners. Do not use furniture wax or polish as
the unit is finished with a protective clear lacquer. It is
recommended to use coasters to protect surface from
heat and water.