Assembly Instruction

4 A) With the assistance of another adult, place tabletop
onto a clean, padded surface. Fit leg assembly into corre-
sponding grooves of tabletop and loosely attach with 2
bolts, 2 flat washers and 2 spring washers per corner
block.
B) Fit dowel of leg assembly into corresponding hole of
long crossbar as shown. Make sure barrel screw is fully
engaged in barrel nut. Insert set screw back into barrel nut
and secure.
A
5 A) Fit remaining leg assembly into corresponding grooves of
tabletop and loosely attach with 2 bolts, 2 flat washers and 2
spring washers per corner block. At this point, fully tighten all
bolts with an allen wrench.
B) Fit dowel of leg assembly into corresponding hole of long
crossbar as shown. Insert set screw back into barrel nut and
secure. With the assistance of another adult, position table
upright. Assembly is now complete.
2 A) Using a screwdriver, remove set screws from
barrel nuts and set aside until further instructions.
Insert 2 barrel nuts into long and short crossbars as
shown. With a flat head screwdriver, make sure holes
of each barrel nut aligns with nearest hole on edge.
B) Insert 1 barrel screw and 1 wood dowel into short
crossbars as shown.
A
A
A
A
Made in China - r04 Page 2 of 3
BUNGALOW EXTENSION DINING TABLE
3 Fit dowels and barrel screws of leg A and leg B into corre-
sponding holes of short crossbar. Make sure barrel screws are
fully engaged in barrel nuts. Insert set screws back into barrel
nuts. Using a flat head screwdriver, turn screws clockwise to
secure.
leg A
short
crossbar
leg B
tabletop
leg assembly
long
crossbar
long
crossbar
short
crossbar
B
NOTE: Do not fully
tighten the bolts
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
NOTE: Make sure
grooves of each leg
are facing outwards
as shown
NOTE: Make sure
holes of each
barrel nut aligns
with nearest edge
with holes
B
B