Assembly Instruction

Made in China - r11 Page 3 of 4
6 Fit dowel of center support into corresponding holes
of assembled unit as shown. Attach each foot and
center support to bottom panel with 1 large bolt, 1
spring washer and 1 flat washer. Secure, but do not
over tighten, bolt with an allen wrench.
BUNGALOW MEDIA STAND
7 Attach 1 pull to each door with 2 small bolts using
an allen wrench.
5 With the assistance of another adult, position bottom
panel onto assembled unit as shown. Secure bottom panel
to front/side panels with 8 medium bolts, 8 spring washers
and 8 flat washers using an allen wrench.
B) Secure bottom panel to partition with 2 large bolts, 2
spring washers and 2 flat washers as shown.
bottom
panel
A
B
8 A) Insert 16 shelf pins into holes at the desired shelf
height. Turn pin clockwise to secure.
B) Place adjustable shelves into assembled unit. Make
sure shelves are securely supported by shelf pins. If the left
door is lower then the right door raise the left side leveling
feet. If the right door is lower then the left door raise the
right side leveling feet.
Assembly is now complete.
NOTE: Make sure shelf
is securely supported
by shelf pins
adjustable
shelves
A
B
A
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
center
support
pull
large
bolt
spring
washer
flat
washer
foot