Assembly Instruction

Made in Thailand r04 Page 3 of 3
BOULEVARD II NIGHTSTAND
4 Place top panel upside down on a padded
surface. Insert 4 wood dowels into the holes as
shown. Turn case assembly upside down and fit
onto wood dowels. Secure top with 4 short bolts.
5 A) Attach the drawer left side panel to the drawer front
and drawer back with 4 shoulder screws. Secure with a
Phillips head screwdriver, but do not over tighten.
B) Slide drawer bottom panel into the groove at
the base of the assembly.
A
B
6 A) Attach right drawer side with 4 shoulder
screws.
B) Attach drawer pull with 2 pull screws. Secure
screws with a phillips head screwdriver.
7 Fit small drawer glide hardware into corresponding large
glide hardware on the case interior. Applying even pressure
to each side of the drawer front, firmly push drawer glides into
the case glides.
Assembly is now complete.
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth. Do not use
abrasive cleaners. Do not use furniture wax or polish as
the wood is finished with a protective clear lacquer.
7 Fit drawer glide hardware into corresponding large
glide hardware on the case interior. Applying even
pressure to each side of the drawer front, firmly push
drawer into case glides. If the drawer fronts are not
aligned, minor vertical adjustments can be made by
loosening the drawer glide screw as shown.
Assembly is now complete.
Customer Service 800.967.6696 | www.crateandbarrel.com