Assembly Instruction

Made in Thailand r04 Page 3 of 3

BOULEVARD II 4 DRAWER CHEST

5 A) Attach the drawer left side panel to the drawer front

and drawer back with 4 shoulder screws. Secure with a

Phillips head screwdriver, but do not over tighten.

B) Slide drawer bottom panel into the groove at

the base of the assembly.

6 A) Attach right drawer side with 4 shoulder

screws.

B) Attach drawer pull with 2 pull screws. Secure

screws with a phillips head screwdriver.

Repeat Steps 5 and 6 for the remaining 3 drawers.

7 Fit small drawer glide hardware into corresponding large

glide hardware on the case interior. Applying even pressure

to each side of the drawer front, firmly push drawer glides into

the case glides.

Assembly is now complete.

CLEANING AND CARE

Clean surfaces with a dry or damp soft cloth. Do not use

abrasive cleaners. Do not use furniture wax or polish as the

wood is finished with a protective clear lacquer.

7 Fit drawer glide hardware into corresponding large glide

hardware on the case interior. Applying even pressure to each

side of the drawer front, firmly push drawer into case glides. If

the drawer fronts are not aligned, minor vertical adjustments

can be made by loosening the drawer glide screw as shown.

Assembly is now complete.

Customer Service 800.967.6696 | www.crateandbarrel.com