Assembly Instruction

HARDWARE

TOOLS REQUIRED

COMPONENTS

Made in Thailand r04 Page 1 of 3

Thank you for purchasing the Boulevard II Four Drawer

Chest. This page lists all the contents included in the

box. Please take time to identify the hardware as well as

the individual components of this product. As you

unpack and prepare for assembly, place the contents on

a carpeted or padded area to protect them from damage.

Note: 2 people are required to safely assemble this

product.

BOULEVARD II FOUR DRAWER CHEST

Missing hardware? Please call 800.606.6387 for replacements.

6 - wood

screws

8- pull

screws

32 - shoulder

screws

4 - wood dowels 4 - drawer pulls

8 - bolts

Allen Wrench (included)

Phillips Head Screwdriver

Customer Service 800.967.6696 | www.crateandbarrel.com

1 - top panel

1 - front rail

2 - side frames

(1 left, 1 right

4 - drawer fronts

1 - back panel

4 - drawer backs 8 - drawer sides

(4 right, 4 left)

4 - drawer bottoms

1 - back rail

PAGE 1
BOULEVARD II FOUR DRAWER CHEST HARDWARE 8 - bolts 6 - wood screws 4 - wood dowels 8- pull screws 32 - shoulder screws 4 - drawer pulls Missing hardware? Please call 800.606.6387 for replacements. Thank you for purchasing the Boulevard II Four Drawer Chest. This page lists all the contents included in the box. Please take time to identify the hardware as well as the individual components of this product.
PAGE 2
BOULEVARD II 4 DRAWER CHEST NOTE: Do not over tighten the bolts Back Rail Front Rail 1 Place left side panel face down on a padded surface. Place the front and back rails into position as shown and attach with 1 bolt per rail. Secure, but do not over tighten each bolt with the allen wrench. 2 Place back panel into position and attach with 3 wood screws. Secure with a phillips head screwdriver. A B 3 A) With the assistance of another adult, carefully place the right side panel into position.
PAGE 3
BOULEVARD II 4 DRAWER CHEST A B 5 A) Attach the drawer left side panel to the drawer front and drawer back with 4 shoulder screws. Secure with a Phillips head screwdriver, but do not over tighten. B) Slide drawer bottom panel into the groove at the base of the assembly. 6 A) Attach right drawer side with 4 shoulder screws. B) Attach drawer pull with 2 pull screws. Secure screws with a phillips head screwdriver. Repeat Steps 5 and 6 for the remaining 3 drawers.