Assembly Instruction

Customer Service 800-967-6696 | http://www.crateandbarrel.com
BALCONY WARDROBE BASE and TOP
Made in Vietnam - r06
Page 2 of 3
1 Place back frame on padded surface as shown. Fit
right and left side panels into position and attach with 4
short screws, 4 split washers and 4 washers per panel.
Secure all screws with the phillips head screwdriver but
do not over tighten.
2 A. Insert top shelf into case at and angle as shown, and
secure to side panels with 4 short screws, 4 split washers
and 4 washers.
B. Position bottom panel as shown and attach with 5 short
screws, 5 split washers and 5 washers. Secure all screws
with the screwdriver.
3 Fit front frame onto assembly. Secure from inside with 8
short screws, 8 split washers and 8 washers as shown.
4 Fit top panel into position and and attach with 6 short
screws, 6 split washers and 6 washers. Fully tighten each
screw with the screwdriver.
x 8
NOTE:
Do not over tighten
the screws.
x 6
x 8
x 9
Make sure the
arrow label
is at the front
of the top panel
B
A
Make sure the arrow label
is at the front of the top panel