Assembly Instruction

ASPEN DESK
Made in Vietnam r07 Page 2 of 2
2 A) With the assistance of another adult, carefully
place tabletop face down on padded surface. Loosely
attach each corresponding leg onto tabletop as shown.
B) Insert 2 flat washers, 2 spring washers, and 2 screw
nuts per leg as shown. Do not fully tighten hardware.
3 A) Insert 2 cams into each short and long
crossbar. Make sure arrow on each cam point
towards edge with holes.
B) Fit 2 short and 1 long crossbars onto assembled
unit by aligning corresponding cam screws and wood
dowels.
4 A) Secure all cams with a flathead screwdriver.
Turn clockwise until each cam securely engages each
cam screw.
B) Fully tighten screw nuts on each leg as shown with
a hex wrench.
5 With the assistance of another adult, carefully
place desk upright. Assembly is now complete.
Make sure arrow
on each cam point
towards edge
with holes.
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth. Do not use
abrasive cleaners. Do not use furniture wax or polish as the
wood is finished with a protective clear lacquer.
A
B
Customer Service 800.967.6696 | www.crateandbarrel.com
long crossbar
short crossbar
B
A
B
A
A
A
B
front
left leg
front
right leg
back
left leg
back
right leg
front of
desk