Assembly Instruction

3 Verify bottom flanges face each other. Using a phillips
head screwdriver, attach top shelf with 4 large screws by
passing screws through flange and into shelf's pre-drilled
holes. Secure all screws but do not over-tighten.
5 Using 1 small screw, attach the long leg of each bracket
to the underside of the desktop. Make sure the face of
short leg is flush with shelf edge.
NOTE: There are multiple holes in the back edge of the
desktop to locate the brackets. Attach brackets at locations
that will correspond to studs in the wall if possible.
4 A) Attach 2nd shelf using same method of assembly as
Step 3. Securely fasten all screws, but do not over tighten.
B) Attach desktop with 12 large screws as shown. Securely
fasten all screws with a phillips head screwdriver.
2 Insert tube caps into ends of both side rails.
BOTTOM
Top Shelf
(underside)
Make sure longer leg of
bracket is attached to shelf
Face of bracket should
be flush with shelf edge
A
B
Page 2 of 3 Made in China - r03
ALTO LEANING DESK
Customer Service 800.967.6696 | www.crateandbarrel.com
NOTE:
Do not over tighten
the screws.