Assembly Instruction

Made in Vietnam - r02 Page 2 of 2

ALPHA TABLE

CLEANING AND CARE

Clean surfaces with a dry or damp soft cloth. Do

not use abrasive cleaners. Do not use furniture wax

or polish as the wood is finished with a protective

clear lacquer. It is recommended to use coasters to

protect surface from heat and water.

Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com

4 A) Fit pre-assembled wood dowel of crossbar into

corresponding hole of leg. Make sure hole in screw post aligns

with hole on end of crossbar.

B) Secure crossbar assembly to leg by inserting a set screw

into barrel nut. Tighten with a phillips head screwdriver,

making sure set screw securely engages the screw post of the

leg.

crossbar

assembly

NOTE: Do not over

tighten the bolts

leg

tabletop

bolt

3 Place tabletop onto a clean, padded surface. Attach 1

leg to tabletop with 2 flat washers, 2 spring washers

and 2 bolts as shown, using an allen wrench. Do not over

tighten the bolts.

2 Place crossbar assembly onto a clean, padded surface.

Insert 3 barrel nuts into crossbar assembly as shown.

Use a flat head screwdriver to align the hole on the side

of the barrel nut with the hole on the end of each crossbar.

Align this hole

with hole on end

of crossbar

crossbar

assembly

CORRECTLY ASSEMBLED

SIDE VIEW DETAIL

5 Repeat steps 3-4 for remaining legs as shown.

Position unit upright. Assembly is now complete.

leg

spring washer

flat washer

set screw

barrel nut

screw post