Assembly Instruction

ManualsBrandsCrate & Barrel ManualsTablesCrate & Barrel Alpha Table

HARDWARE

TOOLS REQUIRED

COMPONENTS

ASSEMBLY

Made in Vietnam - r02 Page 1 of 2

Thank you for purchasing the Alpha Table. This page

lists all the contents included in the box. Please take

time to identify the hardware as well as the individual

components of this product. As you unpack and

prepare for assembly, place the contents on a carpeted

or padded area to protect them from damage.

ALPHA TABLE

Missing hardware?

Please call 800.606.6387

for replacements.

1 - crossbar

assembly

1 - tabletop

allen wrench (included)

phillips head screwdriver

(We recommend the use of hand tools instead of power tools)

3 - legs

leg

flat head screwdriver

Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com

6 - bolts

6 - flat

washers

3 - set

screws

3 - screw

posts

6 - spring

washers

3 - barrel

nuts

1 Place leg onto a clean, padded surface. Insert 1

screw post into each leg and secure with a flat head

screwdriver. Note: Make sure to align slot on top of

screw post parallel to leg. Do not over tighten screw

posts. Repeat for remaining legs.

NOTE: Make sure to

align slot of screw post

parallel to leg

NOTE: Do not over

tighten screw posts

Summary of content (2 pages)

PAGE 1
ALPHA TABLE HARDWARE 6 - flat washers 3 - screw posts 6 - spring washers 6 - bolts 3 - barrel nuts 3 - set screws Missing hardware? Please call 800.606.6387 for replacements. TOOLS REQUIRED allen wrench (included) Thank you for purchasing the Alpha Table. This page lists all the contents included in the box. Please take time to identify the hardware as well as the individual components of this product.
PAGE 2
ALPHA TABLE bolt spring washer flat washer NOTE: Do not over tighten the bolts Align this hole with hole on end of crossbar leg crossbar assembly tabletop 2 Place crossbar assembly onto a clean, padded surface. Insert 3 barrel nuts into crossbar assembly as shown. Use a flat head screwdriver to align the hole on the side of the barrel nut with the hole on the end of each crossbar. 3 Place tabletop onto a clean, padded surface.