Assembly Instruction

Customer Service 800-967-6696 | http://www.crateandbarrel.com
ALDEN FULL, QUEEN BED
Page 2 of 2
Made in Thailand - r04
x 2
2 Attach foot board to each side rail with 2 bolts, 2
split washers and 2 flat washers. Secure all bolts with
the allen wrench.
3 Fit bracket of adjustable support leg onto center rail,
aligning corresponding holes. Make sure brackets at rail
ends face down as shown. Attach with 4 small screws and
secure with a phillips head screwdriver.
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth. Do not use
abrasive cleaners. Do not use furniture wax or polish as the
wood is finished with a protective clear lacquer.
4 Fit metal brackets at ends of center rail into metal
bracket on head and foot boards. Firmly press each end
into position until brackets are snugly engaged.
5 Place slat assembly onto support ledge on inside of
each side rail, aligning holes in slats with holes in support
ledge. Secure with 6 large screws, fully tightening each with
a phillips head screwdriver.
To compensate for uneven floors, adjust leveler on adjustable
support leg as necessary.
Metal brackets
face down