Assembly Instruction

ALDEN FOUR-DRAWER CHEST
Page 2 of 3
Made in Thailand - r04
2 Fit front frame into position, aligning dowels in side
frames with corresponding holes in front frame. Secure
from the inside with 4 bolts per side frame. Do not fully
tighten the bolts.
3 Fit top panel into position, aligning dowels in side
frames with holes in top. Attach top with 11 bolts. At
this point, fully tighten all bolts installed in Steps 1 & 2
with the allen wrench.
NOTE:
Do not over tighten
the screws.
A
B
C
5 A. Attach right drawer side to drawer back and front
with 6 screws.
B. Attach each drawer pull with 1 pull screw. Secure
with a phillips head screwdriver.
C. Repeat Steps A & B for remaining 3 drawers.
A
B
4 A. Fit left drawer side onto drawer back dowels as
shown. Attach with 3 screws and fasten with a phillips
head screwdriver. Do not over tighten the screws.
B. Attach drawer front to drawer side with 3 screws.
C. Slide drawer bottom into slot at bottom of drawer
back, side and front.
D. Repeat Steps A-C for remaining 3 drawers.