Assembly Instruction

Customer Service 800-967-6696 | http://www.crateandbarrel.com

ALCOVE STORAGE CABINET

Made in China - r04

Page 2 of 4

4 Position case assembly as shown. Fit 1 shelf into bottom

of assembly and secure with 4 small wood screws from

below.

At this point fully tighten bolts & screws installed in Steps 1-

4 with a phillips head screwdriver. Do not over tighten the

bolts & screws.

1 A. Attach 1 drawer rail to the inside of each side panel as

shown with 4 long wood screws. Secure each screw with a

phillips head screwdriver, but do not overtighten.

B. Place front frame face down on a padded surface.

Loosely attach 2 side panels with 3 bolts, 3 split washers

and 3 washers per panel. Do not fully tighten bolts.

3 Place back panel face down and position case assembly

as shown. Align dowels with corresponding holes in back

panel and loosely attach with 6 bolts, 6 split washers and 6

washers. Do not fully tighten the bolts.

2 Fit 1 shelf into position as shown. Loosely attach with 4

short screws from below and secure with a screwdriver. Do

not fully tighten screws.

x 2

x 4

x 6

x 4

NOTE:

Do not over

tighten bolts

and screws.