Assembly Instruction

Customer Service 800-967-6696 | http://www.crateandbarrel.com
ACADEMY FULL BED
Made in China 2004
Page 2 of 2
4 A. Fit 1 side slat fitting on one end of each slat.
B. Align pegs on underside of side slat fittings with
corresponding holes on side rails and fit each into position.
2 Align holes in side rails with corresponding holes in
footboard. Attach with 2 large screws, 2 small washers and
2 large washers per side rail. Fully tighten with allen wrench.
3 A. Attach 2 support legs to underside of center rail with
2 small screws and 2 small washers per leg.
B. Place center rail into position and attach from below with
at the headboard and footboard with 2 small screws and
2 small washers.
5 Insert each open slat end into either side of the center slat
fitting. Fit pins of each center fitting to corresponding holes
in the center rail. Repeat until all slats are securely engaged
in each fitting. Assembly is now complete.
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth. Do not use
abrasive cleaners.
Large
Washer
Small
Washer
Large
Screw
A
B
Small
Screw
Small
Washer
A
B
x 13
x 26