Assembly Instruction

Page 3 of 4
ABBOTT
MEDIA GAMING TOWER
Made in China - r06 Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
7 A) Insert 8 shelf pins at desired shelf heights. Place
2 large shelves into assembly as shown.
B) Place 1 small shelf into assembly as shown. Insert 4
shelf pins at desired shelf height. Make sure each shelf
is securely supported by shelf pins.
Assembly is now complete.
B
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth. Do not use
abrasive cleaners. Do not use furniture wax or polish as
the wood is finished with a protective clear lacquer.
6 A) Attach 2 hinge plates to assembled unit as shown. Secure
each hinge plate with 4 screws.
B) Detach hinge bolts in hinge plates using a screwdriver. Fit
hinges of door front into corresponding hinge plates of
assembled unit as shown. Secure each hinge with 1 hinge bolt.
Refer to Hinge Adjustment
diagram for adjusting the
alignment of the door
hinges
A
large shelf
shelf pin
B
A
door front
small shelf
large shelf
If the doors do not appear aligned,
refer to the instructions below:
1) Side to side adjustment:
Loosen screw A, adjust gap
with screw B and re-tighten
screw A.
2) Depth adjustment:
Loosen screw A, push hinge
arm forwards or backwards,
re-tighten screw A and secure
screw B.
1
A
B
A
B
2
HINGE ADJUSTMENTS
NOTE: Door can be
attached to either side of
assembled unit. Pilot holes
on both sides.
B
A