Assembly Instruction

Made in Vietnam - r04 Page 2 of 5
1 A) Insert 6 cam screws into top panel as shown. Secure,
but do not over tighten, cam screws using a phillips head
screwdriver.
B) Insert 4 wood dowels and 4 cams into bottom panel as
shown. Make sure arrows on each cam point toward nearest
edge with holes.
ABBOTT FOUR DRAWER CHEST
3 A) Insert 2 wood dowels and 4 cams into top crossbar
as shown.
B) Insert 2 wood dowels and 2 cams into front and back
crossbars as shown.
4 A) Fit dowels of bottom panel, front crossbar, back
crossbar and top crossbar into corresponding holes of left
side panel as shown. Using a phillips head screwdriver,
turn each cam clockwise until it securely engages each cam
screw.
B) Fit dowels of assembled unit into corresponding holes of
right side panel as shown. Secure all cams.
bottom panel
2 Insert 5 cam screws and 2 cams into left and right side
panels as shown.
top panel
left side panel
front and back
crossbars
A
B
B
right side panel
front
crossbar
bottom
panel
left side panel
back
crossbar
right side panel
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
NOTE: Do not over
tighten the cam screws
NOTE: Make sure arrows
on each cam point toward
nearest edge with holes
top crossbar
A
top
crossbar
B
A