Assembly Instruction

Page 4 of 6
ABBOTT
MEDIA STAND
Made in China - r12 Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
10 A) Attach drawer side panel to drawer back panel
and small drawer front panel with 6 large screws as
shown.
B) Slide bottom panel into corresponding grooves of
assembled drawer unit.
8 With the assistance of another adult, carefully position unit
upright. Fit dowels of top panel into corresponding holes of
assembled unit. Secure top panel to assembled unit with 9
bolts as shown, using a screwdriver.
top panel
9 With the assistance of another adult, position unit face
down as shown. Attach back panel to assembled unit with
16 large screws as shown.
back panel
drawer
side panel
drawer
back panel
small drawer
front panel
drawer
side panel
11 Attach drawer side panel to assembled unit with 6
large screws as shown.
bottom
panel
A
B
VIEW FROM
BELOW
NOTE: A short screwdriver is
recommended to tighten small
bolts during this assembly. Do
not over tighten bolts.