Assembly Instruction

ABBOTT CORNER MEDIA STAND
Made in China - r07 Page 2 of 5
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
NOTE: Do not over
tighten the cam screws
partition
1 Carefully place front frame onto a clean, padded
surface. Insert 11 wood dowels and 4 cam screws into
front frame as shown. Secure, but do not over tighten,
cam screws using a phillips head screwdriver.
front frame
2 A) Insert 6 wood dowels into partition as shown.
B) Insert 1 wood dowel into left and right side panels as
shown.
4 A) Fit dowels of partition into corresponding holes of
bottom panel as shown.
B) Secure partition to bottom panel with 4 large screws
using a phillips head screwdriver. Do not over tighten
the screws.
NOTE: Make sure arrows on
each cam point toward nearest
edge with holes
A
NOTE: Do not over
tighten the screws
bottom
panel
partition
bottom
panel
A
B
left and right
side panel
3 Insert 4 cams into bottom panel as shown. Make sure
arrows on each cam point toward nearest edge with
holes.
B