VTX30 Two-Channel Guitar Amplifier with Digital Signal Processing User’s Guide
VTX30 Two-Channel Guitar Amplifier with DSP TABLE OF CONTENTS: Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 The Top Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . .4,5 The Bottom Panel . . . . . . . . . . . . . . . . . . . . . . . . . . .5 The DSP Section . . . . . . . . . . . . . . . . . . . . . . . . . . . .6 System Block Diagram . . . . . . . . . . . . . . . . . . . . . . .7 Technical Specifications . . . . . . . . . . . . . . .
VTX30 Two-Channel Guitar Amplifier with DSP Congratulations and thank you for choosing the Crate VTX30 Guitar Amplifier with Digital Signal Processing. This rugged amplifier features a Clean channel with a three-band EQ and level control, and a Solo channel with our patented FlexWave technology, Gain, Level and Shape control. An easy to operate DSP section lets you dial in a variety of digital effects including reverbs, delays, octave and wah-wahs.
VTX30 Two-Channel Guitar Amplifier with DSP The Top Panel: SOLO INPUT GAIN SHAPE LEVEL 2 3 4 LOW MID HIGH LEVEL CLEAN SOLO 1 DSP CLEAN LEVEL 5 6 7 8 9 10 POWER DELAY FLANGER 1 FLANGER 2 CHORUS 1 CHORUS 2 ROTARY OCTAVE T-WAH I-WAH DOUBLER REVERB 11 CD INPUT 12 13 14 1: INPUT: Use this 1/4” jack to connect your guitar to the amplifier by means of a shielded instrument cable. SOLO CHANNEL: A high gain channel giving you sounds from a slight edge to serious overdrive.
VTX30 Two-Channel Guitar Amplifier with DSP 14: POWER: Use this switch to turn the amplifier on (top of the switch depressed) and off (bottom of the switch depressed). The switch illuminates when the amplifier is turned on. 15: TUNER: The electronic tuner is active whenever the amplifier is turned on, providing constant, “real-time” tuning. The bottom row of LEDs indicate which note (string) is being tuned.
VTX30 Two-Channel Guitar Amplifier with DSP The DSP Section: Use the DSP control to select one of the 16 built-in digital effects. Use the DSP Level control to adjust the amount of selected effect. In the fully counter clockwise position there will be no effect applied. As you rotate the Level control clockwise the amount of effect increases.
VTX30 Two-Channel Guitar Amplifier with DSP System Block Diagram: TUNER A BC D EF G BUFFER INPUT CLEAN LEVEL LOW MID FOOTSWITCH JACK HIGH SOLO/ CLEAN SOLO GAIN SHAPE LEVEL POWER AMP SPEAKER DSP LEVEL MODE EXTENSION SPEAKER CD INPUT 7
VTX30 Two-Channel Guitar Amplifier with DSP VTX30 TECHNICAL SPECIFICATIONS: Output Power Rating Gain >30W RMS @ 5% THD, 4Ω, 120 VAC Solo Ch 98dB +/-6dB @ 1kHz Clean Ch 42dB +/-6dB @ 1kHz Maximum Input Signal Accepted Tone Controls 6 volts peak-to-peak min.
