Owner’s Manual
GFX-65T Guitar Amplifier with DSP & Channel Tracking Congratulations! You are now the proud owner of the Crate GFX-65T amplifier. This rugged amplifier combines outstanding features with serious clean and distorted sounds. An easy to operate DSP section lets you dial in a variety of digital effects including reverbs, delays, octave and wah-wahs – with a separate level control.
GFX-65T Guitar Amplifier with DSP & Channel Tracking The Digital Signal Processor: Crate’s Digital Signal Processing offers 16 exciting digital effects, accessible through the DSP Mode control. The effects are described below.
GFX-65T Guitar Amplifier with DSP & Channel Tracking The Front Panel: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 1: INPUT: Use this 1/4” jack to connect your guitar to the amplifier by means of a shielded instrument cable. OVERDRIVE CHANNEL: A high gain channel giving you sounds from a slight edge to serious overdrive. 2: GAIN 1: Use this control to adjust the amount of light distortion for the Overdrive channel.
GFX-65T Guitar Amplifier with DSP & Channel Tracking The Electronic Tuner: 20 20. ELECTRONIC TUNER (top panel): This active electronic tuner is on whenever the amplifier is turned on, allowing you constant, “real-time” tuning. The bottom row of LEDs indicate which string is being tuned, while the top row of LEDs are your guiding lights: use the flat and sharp indicators until the center LED illuminates. This indicates a properly tuned string.
GFX-65T Suggested Settings: 6 Guitar Amplifier with DSP & Channel Tracking
GFX-65T Guitar Amplifier with DSP & Channel Tracking System Block Diagram: TUNER A BC D EF G INPUT CLEAN CHANNEL BUFFER CHANNEL SELECT LEVEL LOW MID HIGH FLEX WAVE STAGE OVERDRIVE CHANNEL SHAPE ACTIVE GAIN GAIN EQ LOW HIGH LEVEL SHAPE MIX AMP DSP INSERT LEVEL POWER AMP SPEAKER MODE DAMPING CIRCUIT EXT.
GFX-65T Guitar Amplifier with DSP & Channel Tracking GFX-65T TECHNICAL SPECIFICATIONS: Output Power Rating Speaker Size and Rating Input Impedance Total System Gain Overdrive Ch Clean Ch Maximum Input Signal Accepted Overdrive Channel Low Control Shape Control High Control Clean Channel Low Control Mid Control High Control Power Requirements Size and Weight 65W RMS @ 5% THD, 4Ω, 120 VAC (1) Custom Design 12”, 4Ω 470kΩ Gain 1: 88dB, all controls @10; Gain 2: 110dB 58dB, all controls @10 7 volts peak-to-pe
