Specifications

6
ASSEMBLY
ALWAYS use fresh cool water when operating the humidifier.
1. Turn Water Tank upside down and unscrew Water Tank Cap.
2. Fill Water Tank with cool water. DO NOT fill water all the way to the rim.
DO NOT CARRY FULL WATER TANK BY HANDLE.
ALWAYS HOLD FULL WATER TANK WITH TWO HANDS.
DO NOT use hot water. Use cool tap water.
DO NOT add any medication, essential oils, or salt.
DO NOT pour water into Mist Outlet Channel.
3. Screw Water Tank Cap back onto Water Tank. Turn the Water Tank over and
place on Water Basin, making sure it fits perfectly.
Note: Do not attempt to move the humidifier while Water Tank is placed on
Water Basin. Doing so may cause leakage of water and/or Water Basin to
overfill.
4. Plug the power cord into a wall socket and turn on the unit by using the Control
Knob.
5. Select Cool Mist or Warm Mist on the Cool/Warm Mist Selection Knob. The blue
Power Indicator Light will illuminate. In a few seconds, mist will start emitting.
6. Use the Mist Control Knob to adjust the intensity of the mist output.
SET THE CORRECT HUMIDITY OUTPUT: Adjust the Control Knob so that the mist
rises up to be absorbed by the room air. Do not set Control Knob too high, as the
mist cannot be absorbed by the air and may accumulate on the surfaces around the
humidifier.
7. When the humidifier runs out of water, the humidifier will automatically shut off
and the mist will stop. The Low Water Indicator Light will illuminate red. This
safety feature uses a water level sensor to stop the Nebulizer once the water
level sinks below the required level in the Humidifier Base.
Note: The indicator light on the humidifier will remain on. The red light
indicates that the humidifier is turned on and needs to be refilled.
Product Support: Contact Crane at 888-599-0992
Sales Inquiries: Contact Sylvane at 800-934-9194 or visit sylvane.com