Specifications

6
ASSEMBLY
ALWAYS use fresh cool water when operating the
humidifier.
1. Turn Water Tank upside down and unscrew Water
Tank Cap.
2. Fill Water Tank with cool water to fill line.
DO NOT fill water all the way to the rim.
DO NOT CARRY FULL WATER TANK BY HANDLE. ALWAYS HOLD WATER
TANK WITH TWO HANDS.
DO NOT use hot water. Use cool tap water.
DO NOT add any medication, essential oils, or salt.
DO NOT pour water into Mist Outlet Channel.
3. Screw Water Tank Cap back onto Water Tank. Turn the
Water Tank over and place on Water Basin, making sure
it fits perfectly.
Note: Do not attempt to move the humidifier while
Water Tank is placed on the Water Basin. Doing so may
cause leakage of water and/or Water Basin to overfill.
4. Plug the power cord into a wall socket and turn
on the unit by using the Control Knob.
5. The Power Indicator Light will illuminate in red.
Within a few seconds, it will switch to green,
indicating that there is enough water in the
Water Basin. Mist will begin emitting through
the Mist Lid.
6. Use the Control Knob to adjust the intensity of the mist output. It is best to have
the mist knob at a medium setting.
SET THE CORRECT HUMIDITY OUTPUT: Adjust the
Control Knob so that the mist rises up to be absorbed
by the room air. Do not set Control Knob too high, as
the mist cannot be absorbed by the air and may
accumulate on the surfaces around the humidifier.
7. When the humidifier runs out of water, the Power
Indicator Light will turn red and the mist output will
stop. This is a safety feature to prevent the
humidifier from possibly overheating and damaging
the Nebulizer. Turn the humidifier off and unplug the
unit before removing and refilling the water tank.
Note: The Power Indicator Light on the humidifier will remain on. The
red light indicates that the humidifier is turned on and needs to be
refilled.