Specifications

6
LCD DISPLAY SUPPORT BATTERIES
The support batteries will save the clock and time. Once the unit is disconnected from
the main power source the LCD display will go off but the batteries will allow the clock to
keep operating
Please Note:
• The humidifier can be operated without support batteries.
• The humidifier cannot be operated only on the support batteries.
• The humidifier comes with support batteries in the humidifier battery
compartment. The support battery is protected by a plastic strip. The plastic
strip must be removed to activate the batteries.
• The battery compartment for the support batteries is located at the bottom base
of the humidifiers.
TO REPLACE SUPPORT BATTERIES
1. Press the battery compartment tab and lift the compartment lid. Remove the
three LR44/3V batteries
2. Insert three LR44/3V batteries into the battery compartment. Please observe the
correct +/- battery polarity. The + polarity must point upwards.
3. Properly replace the battery compartment lid.
HOW TO SET CLOCK
As soon as the humidifier is connected to the power source the LCD display on the clock
will illuminate blue.
1. Press the button HI/LO SET and hold until the first two numbers will blink.
2. Press the FUNCTION button to adjust the correct hour. NOTE: If you keep the
FUNCTION button pressed the hour will SET.
3. Press the HI/LO SET button again and the last two numbers will blink.
4. Press the FUNCTION button to adjust the correct minutes.
5. Press the HI/LO SET several times until the correct clock time appears on display.
NOTE: You will need to press through other functions until the clock time you
set appears.
HOW TO OPERATE THE HUMIDIFIER FEATURES
AUTO OFF SAFETY FEATURE
As soon as the water in the water tank runs low the humidifier will automatically switch
OFF. The set LCD Clock will remain on.
Setting HI/LO Output
1. As soon as the humidifier is switched ON it will operate on the HI output. HI will
appear on the upper right corner of the display.
2. Press the HI/LO SET to reduce output. LO will appear on the lower right corner of
the display.
3. The output will be reduced and less mist will be emitted into the air.
4. To increase the output press the HI/LO button again.