Tower Fan MODEL# EE-5607 PLEASE READ THESE AND SAVE ALL INSTRUCTIONS TO ENSURE THE SAFE AND EFFECTIVE USE OF THIS APPLIANCE.
TABLE OF CONTENTS Table of Contents P.1 Important Safety Instructions P.2 General Safety Instructions P.3 List of Main Parts, Tech. Specifications, Contents of Packaging P.4 Before First Use, How to Assemble, How to Operate P.5 Maintenance, Service Center P.6 Warranty Information P.7 Warranty Card P.
IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic safety precautions should also be observed, including the following. PLEASE READ AND SAVE ALL INSTRUCTION BEFORE USING THE TOWER FAN. 1. Always turn the fan off before removing the plug from the outlet. NEVER PLUG OR UNPLUG UNIT WITH WET HANDS. 2. Always turn the fan off and unplug it immediately after using and before cleaning. 3. To protect against electrical hazards, do not place the fan in water or other liquids.
GENERAL SAFETY INSTRUCTIONS WARNING! Read and understand all instructions. Failure to follow all instructions listed below may result in electric shock, fire or serious personal injury. The warnings, cautions, and instruction discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are a factor which cannot be built into this product, but must be supplied by the operator.
LIST OF MAIN PARTS 1. 2. 3. 4. 5. 6. Remote Controller Main Body Base Base Screw Clamp Screw Power Cord & Plug TECHNICAL SPECIFICATIONS: Model Number Rating Voltage Rated Wattage EE-5607 120VAC 60Hz 40W CONTENTS OF PACKAGING a. b. c. d. e. Instruction Manual Tower Fan main body Base 3x Base Screws 2x Clamp Screws If any of the above items are missing, please contact our service department at 1-888599-0992 (http://www.crane-usa.com) for replacement. Business hours Mon-Fri 9:00am-4:00 pm CT.
BEFORE FIRST USE IMPORTANT: Remove the clear plastic sticker that is visible at the bottom of the remote controller (see drawing below). HOW TO ASSEMBLE NOTE: Refer to LIST OF MAIN PARTS on page 4. 1. Lay the main body of the fan gently on floor, take the base (3) and place power cord (6) in the cord groove. 2. Attach the fan body and the base by tightening the base screws (4) with a screwdriver. 3. Secure power cord (6) to base (3) with clamp screws (5).
MAINTENANCE CAUTION: Always be sure that the appliance is switched OFF before cleaning the appliance or attempting to store the item. ALWAYS plug and unplug unit with dry hands. Before cleaning, turn the fan off and unplug from electrical outlet. Wipe off excess dust with a lint free cloth. A vacuum cleaner hose can be used to clean this area if desired. The exterior of the fan housing can be cleaned with warm (not hot) soapy, mild detergent solution. Wipe dry.
LIMITED WARRANTY Thank you for purchasing a top quality Crane product. This Tower Fan was tested and meets our stringent quality standards. This product is warranted to be free from manufacturing defects under normal use and conditions for 1 year. WARRANTY IS ONLY VALID WITH A DATED PROOF OF PURCHASE.
WARRANTY CARD In case you find this product to be defective please proceed as follows: A. Within 90 days of purchase: return the product to your retailer for a replacement or a refund. B. After 90 days and within the warranty period: send the product and all of it’s accessories to our service center. The consumer will be responsible for all shipping costs to the Crane Service Center. Crane will not assume responsibility for loss or damages to the product being returned to us.
