Full Product Manual

6
1. Turn Water Tank upside down, unscrew Water Tank Cap and fill with cool water only.
ALWAYS HOLD WATER TANK WITH TWO HANDS WHEN FULL.
DO NOT fill water all the way to the rim.
DO NOT use hot water.
DO NOT add any medication, essential oils, or salt.
DO NOT pour water into Mist Lid.
2. Screw Water Tank Cap back onto Water Tank and turn the
tank over to place on Humidifier Base, making sure it fits
together securely.
Note: Do not attempt to move the humidifier while full Water
Tank is placed on the Humidifier Base. Doing so may cause leakage of water and/or
Humidifier Base to overfill.
3. Plug the power cord into a wall socket and turn on the unit by using the Control Dial.
4. The green Power Indicator Light will illuminate indicating that there is enough water
in the Humidifier Base and mist will begin emitting through the Mist Lid.
5. Use the Control Dial to adjust the intensity of the mist output.
SET THE CORRECT HUMIDITY OUTPUT: Adjust the Control Dial so the mist rises up to be
absorbed by the room air. If mist drops quickly, turn down the control knob until the mist
is rising up.
6. When the humidifier runs out of water, the red Power Indicator Light will illuminate
and the mist output will stop. This is a safety feature to prevent the humidifier from
possibly overheating and damaging the Nebulizer. Turn the humidifier off and
unplug the unit before removing and refilling the water tank. When emptying the
base, be sure to pour away from the fan outlet.
A NOTE ABOUT HUMIDITY
 To reduce excessive humidity or condensation, especially in small rooms, leave the room
door open and adjust mist intensity to the low output setting.
 Too much humidity in the room may allow moisture to accumulate on surfaces where
bacteria and fungi can grow. Moisture that gathers may also damage furniture and
walls, especially wallpaper.
MAINTENANCE
Cleaning and disinfecting on a regular basis is important for maintaining the
performance of your humidifier.