Operator`s manual

3. To change the time shown, press the access key.The display will now show:
4. Enter the correct time in hours and minutes using buttons 0 - 9 on the keypad.
5. When correct, press access.The time is now set.To view the date, press the up
or down key until the display reads:
where xx:xx:xx is the current date.
6. To change the date, press the access key.The display will now show:
7. Enter the correct date using the sequence day, month, year using buttons 0 - 9 on
the keypad.
8. When correct, press access.The date is now set.To view the day, press the up or
down key until the display reads:
where xxxxxxxxx is the current day of the week.
9. To change the day, press the access key.The display will now show:
10. Use the up or down arrow keys until the required day is displayed.Press the access
key. The time, date and day are now programmed.
Operator Code Sub-Program (Default 17)
Entry into the Operator code sub-program enables the operator code to be changed.
This code may be of any length up to seven digits. Enter a new code at the prompt
and when correct press the access button.
28
Operator’s Manual
DAY = XXXXXXXXX
> XXXXXXXXX
DAY = XXXXXXXXX
TIME = XX:XX
SET TIME > 00:00
DATE = XX:XX:XX
DATE = XX:XX:XX
SET DATE > 00:00:00